MS-DOS 6.22 bootable floppy image with CD driver by ? (unknown) This is a non-bootable CD that will install Windows 3.1 without the need for floppies.īoot your DOS install that has a CD driver installed (option 2 from Looka's CD above), run "setup.exe" on the CD and you're done.įile: Windows_3.1_Install_CD_Not_Bootable_EX.isoģ. One of my go-to's for DOS 6.22 installs and the CD driver is a nice bonus.įile: DOS622_Install_CD_by_Looka_Bootable_EX.iso Saves a lot of time in testing DOS in VMs. Option 1 will install MS-DOS 6.22 and option 2 will then install a CD driver to the hard disk. It boots using floppy emulation that also loads a CD driver that is then used to start the DOS install process on the CD. This is a bootable CD to install MS-DOS 6.22 without futzing around with floppy disks. That’s it! As you can tell, restoring the Compaq Portable 386 is relatively straightforward if you’re even mildly tech-savvy- the components are pretty robust, and due to the price of the computer at the time, they were built to last.These are 2 install CDs and 1 bootable floppy image that I've found invaluable for testing DOS and Windows 3.1 in virtual machines as they can install DOS 6.22 and Windows 3.1 from CD without the need for floppy disks or floppy image files. You should now be able to boot your Compaq Portable 386 to its hard disk MS-DOS prompt without needing the dos floppy. If, after MS-DOS installation, you get an error message such as “Operating system not found” or something similar, boot to your dos floppy and type “FDISK/MBR.” After executing FDISK/MBR, restart the computer once more. It seems this step may be necessary even after an MS-DOS installation else, you won’t get a hard disk command prompt. Once you have successfully installed MS-DOS, boot again from your dos boot disk, and then type FDISK /MBR at the command prompt – this adds the master boot record to your disk allowing your computer to boot from the CF card / hard disk directly. Follow the commands in FDISK to create your MSDOS partition(s) first (in case you want to set up multiple partitions or adjust their sizes), then restart and resume MS-DOS setup. Exit the setup program (press F3) and type FDISK at the command prompt, and press enter – if all is well, the FDISK program should load and give you a series of choices – press “4” to view the existing disk, partitions, and logical drives. I recommend exiting MS-DOS setup to check that the hard disks / compact flash cards are configured correctly. If you don’t have a setup disk and just used an MS-DOS boot disk, the computer should at least boot to command prompt, showing “A:/>”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |